Pro Design Motor Kits

  • Home
  • About
  • Installation
    • Installing Motor Kit to Headrail
    • Wand Control Programming Instructions
    • Remote Control Programming Instructions
  • Shop Wand Control
  • Shop Remote Control
  • Account Set Up
  • Home
  • About
  • Installation
    • Installing Motor Kit to Headrail
    • Wand Control Programming Instructions
    • Remote Control Programming Instructions
  • Shop Wand Control
  • Shop Remote Control
  • Account Set Up

Wand Control Operating Instructions


Download Programming Instructions

Attach Wand Control to Motor

1. To attach your wand control to the motor, lift the protective cover on the motor interface and insert the plug on the end of the wand cable. Use a pencil eraser to push firmly on the plug, ensuring that it is fully seated. 
Picture
2. Insert the shepherd's hook on the end of the wand into the eyelet on the motor crown and push it all the way through so the wand hangs freely. Be sure that the three buttons on the wand are facing forward. 
Picture

Charge the Motor Battery

1. Plug the recharger into the micro USB recharging port on the back of the wand and the other end into an AC outlet. 
Picture
2. If the battery is fully charged, the LED light on the front of the wand control will glow green. If not, the light will glow red. Let the wand charge until the LED light is green. Then, unplug the charger. 
Picture

Operate the Shade

1. To operate the shade, start by resetting the shade motor. Do this by pressing and holding the setting button on the motor head until the shade jogs 3 times. This will enter your shade motor into programming mode. 
Picture
2. While in programming mode, set the upper, lower, and middle stop limits. 
  • To set the upper limit, move the shade to the desired upper stop limit and then press and hold the UP and STOP buttons together until the shade jogs twice. 
  • To set the lower limit, move the shade to the desired lower stop limit and then press and hold the DOWN and STOP buttons together until the shade jogs twice. 
  • To set the middle limit, move the shade to the desired middle stop limit and then press and hold the STOP button until the shade jogs. 
3. Once your limits are set, you can operate the shade by pressing the UP, STOP, and DOWN buttons on your remote. 
Picture

Resetting Shade Limits

1. Resetting the upper limit:
  • Press the UP button to move the shade to the current upper stop limit. 
  • Press and hold the UP and STOP buttons together until the motor jogs once to put the shade into programming mode. This may take up to 10 seconds. 
  • Move the shade to the desired upper limit.
  • Press and hold the UP and STOP button together until the motor jogs two times. This will set the new limit and exit programming mode. 
2. Resetting the lower limit:
  • Press the DOWN button to move the shade to the current upper stop limit. 
  • Press and hold the DOWN and STOP buttons together until the motor jogs once to put the shade into programming mode. This may take up to 10 seconds. 
  • Move the shade to the desired lower limit.
  • Press and hold the DOWN and STOP button together until the motor jogs two times. This will set the new limit and exit programming mode. 

3. Resetting the middle limit:
  • Move the shade to the desired middle stop limit. 
  • Press and hold the STOP button until the shade jogs. 

Troubleshooting

  • Shade is operating in reverse: To reverse the shade direction, press and hold the setting button on the motor head until the motor jogs 2 times.
​
About
Installation
Shop Wand Control
Shop Remote Control

Pro Design in Twinsburg, OH on Houzz
Phone: 330-562-0023
Fax: 928-447-1087
Email: info@prodesignllc.net
Picture